AudioControl LC6 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AudioControl LC6. AudioControl LC6 16 pagina's. Six channel line output converter
Pagina afdrukkenA Guided Tour of LC6
Speaker-level Inputs: The LC6 has six speaker-level inputs. These
inputs get their signals from the speaker-level outputs of the source unit or
factory-installed amplifier if your vehicle is so equipped. If your source
unit has front, rear, and subwoofer speaker-level outputs, connect them to
identical inputs on your LC6. If the source unit only has front and rear
inputs, the Auto Mode circuitry in your LC6 automatically routes the rear
input channels to the subwoofer channels.
Ground – Connect to a good, verified chassis ground (the battery
comes to mind.) Warning: Factory ground wires typically already have
multiple devices connected to them and are not recommended.
+12 – Connect to a good source of power (the battery comes to mind
again)
Remote In – Allows your LC6 to be turned on remotely with a 12
volt signal
Remote Out – Outputs 12 volts when the LC6 is powered up so you
can turn on external devices like signal processors and external amplifiers.
Maximized Indicator - This brightly colored LED indicates when
your signal level is just below clipping your LC6. When properly level
matched, this LED should only flicker occasionally when your system is
playing at its maximum volume level.
Power – If you have connected all of your power wires correctly, this
light should be bright red when your system turns on.
Figure 2: LC6 top cover
page 5