- ページ 9
メディア・コンバーター AudioControl LC6のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AudioControl LC6 16 ページ。 Six channel line output converter
ページを印刷するFigure 6: Automode switching - four input channels providing six output
channels
Speaker-Level Inputs
The LC6 is designed to accept an amplified, speaker-level signal from
a factory source unit or amplifier. You will want to refer to a factory
service manual or wiring-harness schematic to determine which wires are
the speakers wires for your system. If you are unsure which wires are the
speaker wires, it is recommended you look at the color of the speaker
wire connected to the speakers and follow them back to the factory
source or amplifier. Connect the speaker wires to the "Speaker-Level
Inputs" on your LC6. Make sure to get your "pluses" and "minuses"
connected properly.
Pre-Amp Outputs
Connect good quality RCA connectors from these outputs to the inputs
of your amplifiers. While we won't get into the discussion as to whether
plutonium cables sound better than un-obtainium cables, we will tell you
that well-constructed cables are less problematic in rugged environment
like your car system.
page 9