- ページ 10

メディア・コンバーター AudioControl LC7のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AudioControl LC7 16 ページ。

Figure 6: Six channel system with LC7 and EQS

Speaker-Level Inputs

The LC7 is designed to accept an amplified, speaker-level signal from

a factory source unit or amplifier. You will want to refer to a factory

service manual or wiring-harness schematic to determine which wires

are the speaker wires for your system. If you are unsure which wires

are the speaker wires, it is recommended you look at the color of the

speaker wire connected to the speakers and follow them back to the fac-

tory source or amplifier. Connect the speaker wires to the Speaker-Level

Inputs on your LC7. Make sure to get your "pluses" and "minuses" con-

nected properly.

Auxiliary Input

Many car audio enthusiasts have a number of sources of music, above

and beyond their factory-installed source unit. Downloading music from

the Internet onto an iPod or an MP3 player is getting more and more pop-

ular. By last count there were only 100,000,000 users! To help interface

one of these audio devices, the LC7 is equipped with two-channel audio

input. To trigger this input, you need to tap the dash control auxiliary

knob and the LC7 will switch between the main inputs and this auxiliary

input. A bright LED indicator on the LC7 chassis will identify which

source unit is being used. On this topic, the LC7 provides you with a

level control for your auxiliary source which allow you to match the sig-

nals between your main source and your auxiliary. That way, when you

switch between your iPod and the main radio inputs, the volume level

won't blow your ears off.

Pre-Amp Outputs

Connect good quality RCA connectors from these outputs to the inputs

of your amplifiers. While we won't get into the discussion as to whether

plutonium cables, sound better than un-obtainium cables we will tell you

that well-constructed cables are less problematic in a rugged environment

like your car system.

page 0