- ページ 8

メディア・コンバーター AudioControl LC7のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AudioControl LC7 16 ページ。

LC7 Block Diagram

Installing Your LC7

By this time we are sure that you are chomping at the bit to install your LC7.

Up to this point, everything you have read has served to educate you on the

operations of LC7. Therefore if you are still with us we recommend you read

the following sections very carefully.

Placement & Mounting of the LC7

Your LC7 can be physically installed in numerous locations like behind your

dashboard, under a seat, or even in the trunk. Since you will be connecting to

the speaker wires from the factory source unit or its amplifier(s), you should

select a location that is convenient for wiring. Once you have selected a perma-

nent mounting location, position the unit and mark the appropriate mounting

holes with a felt-tip pin or scratch awl. Before doing anything else, make sure

you are not about to drill a hole in a gas tank or pierce any existing wiring.

Nothing ruins your day more than an expensive repair bill. Drill a few small

pilot holes and secure the chassis of the LC7 with self-tapping screws.

LC7 Power Wiring

WARNING: Failure to disconnect the negative terminal of your battery prior

to the installation of your LC7 can result in a warm tingly feeling.

(+12V) Positive Connection: Insert a 12 to 18 gauge wire into the connec-

tor labeled "+12" on the nifty connector of your LC7. Connect it to a good

constant source of 12 volts (we suggest the battery), fused at 1 amp.

page