- ページ 6
インターホン・システム dupol up200-gsmのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dupol up200-gsm 7 ページ。 Intercom and access control unit operating on mobile gsm network
ページを印刷するINSTALLATION
Mounting
Measure the GSM signal with your mobile phone. It
may happen that in the desired place of installation
the signal strength is not satisfactory. In this case
you can move the unit or the GSM antenna in a
more suitable place before installation.
Do not mount the unit where it could be affected by
strong electromagnetic disturbances.
Antenna: the GSM antenna supplied with the unit
provides good transmission under normal reception
circumstances. In case of having signal strength
problems and/or noisy communication, use other
type of higher gain antenna or find a more suitable
place for the antenna.
Inserting the SIM card: pull the metallic part of the
SIM case towards the center of the panel to open up
the SIM slot for inserting the card. Insert the SIM
card into the slot so that its contact surface should
point towards the contact pins of the card case
when turned down, as well as the cut corner of the
card should fall towards the edge of the panel, in the
direction of the LEDs. Fasten the SIM card by
pulling back the metallic part of the SIM case.
Connection diagram
①
②
⑬
⑫
⑪
③ ④
⑤
⑥
⑩
⑨
Putting into operation
Disable PIN code request, voicemail and missed
call notification service on the SIM card.
Enable caller identification and caller ID sending
service on the SIM card at the GSM service
provider.
Make sure the SIM card is inserted properly into its
case.
Make sure the antenna is fixed properly into the
SMA connector.
Make sure the wires are connected as shown in
the connection diagram.
Make sure the power supply is sufficient for the
operation of the unit! If it is, and all connections are
done, the unit can be powered up.
If operated without an electric lock from a 16V AC
transformer, the current requirement is 300mA
(5VA).
When operated with an electric lock, the
minimum power requirement is 20VA!
⑦
① GSM antenna connector
② Contact input
③ Relay contact output
④ Voltage output
⑤ Power input
⑥ Speaker output
⑦ Microphone input
⑧ Battery connector
⑨ Name plate lighting
⑩ USB mini B port
⑪ Call pushbuttons
⑧
⑫ Status LEDs
⑬ SIM card case
UP200-GSM Rev.1.2 08/01/2014
solar powered version only!