- ページ 15

オーブン Daniela DAN6FGSのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Daniela DAN6FGS 20 ページ。

ページを印刷する

ADJUSTMENTS

• Before any adjustment is attempted, which

may be necessary when installing for the first

time or when converting gas type, take the

plug out of the mains socket.

• When the adjustment or preadjustment has

been made, a technician must do any re-

sealing.

• Adjust "Minimum" only when the burners

are working on natural gas while in the case

of burners working butane and propane gas,

the screw must be screwed right down (by

screwing the by-pass clockwise).

OVEN THERMOSTAT (fig. 10)

To adjust Minimum proceed as follows:

• Light the oven burner by turning the knob round

to the Maximum position and then wait about 10

minutes.

• Turn the knob slowly round to the Minimum

position, take the knob off, unscrew the right-hand

screw securing the thermostat and, putting a small

screwdriver (C) in hole (F), turn the (V) screw

clockwise to lower the flame or counterclockwise

for a taller flame.

• The flames must be short for an effective Minimum,

they should be stable to avoid going out accidentally

and to resist the normal opening and shutting of the

oven door.

�

INSTRUCTION FOR THE INSTALLER

�

OVEN BURNER (fig. 11)

The burner is at the bottom of the oven and covered

by the base tray that must stay in position all the time

the oven is being used.

CONVERSION

CHANGING THE INJECTORS

The burners can be adapted to different types of gas

by simply installing the injectors suitable for the gas

you want to use.

To change the injector of the (BF) oven burner you first

have to remove it, unscrewing screws (V) (fig. 11).

To help the installer there is a table on page 12 giving

burner power, nominal heat input, injector diameter

and working pressure of the different gas types.

After the injectors have been changed, the

technician must adjust the burners as described

in the previous paragraphs, seal any adjustment

or preadjustment parts and affix the label on the

appliance, in place of the old one, relative to

the new gas adjustment. This label is inside the

spare injector bag.