- ページ 6
スピーカー Audiophile Systems COA MOJO1000FXのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Audiophile Systems COA MOJO1000FX 12 ページ。 Amplified system with subwoofer and satellites + dsp effects and bluetooth®
ページを印刷する
English
MOJO1000fx - Amplified system with subwoofer and satellites + DSP multi effects and Bluetooth
4-Multi effects DSP LEDs
This LEDs allow you to know which effect is selected by the N°11 selector.
5- Subwoofer sound level
The subwoofer volume can be adjusted separately. Use this knob to adjust it as desired. By default, the system is
balanced when this knob is in middle position.
(PLEASE MAKE SURE TO CONFIGURE IT IN ORDER TO PREVENT THE LIMIT FROM BEING LIT)
6 - Multi effects switch
Allow to switch On or Off the effects
7- Satellites output configuration
Left selector: Stereo mode if both outputs are active and the two satellites separated to be used as a 2.1 sound
system.
Right selector: Mono mode, the left output only is active and the two satellites are linked together to focus their power
on one single side.
8- High and Low equalizer
Allows you to equalize the master high and low signal
9 - ON/LIMIT signal indicator
Allows you to check on the volumes
(PLEASE MAKE SURE EACH CHANNEL IS CONFIGURED IN ORDER TO PREVENT THIS INDICATOR FROM BEING
LIT)
10 - Effects routing level
Allows o adjust the main level of the effect injected in the mixer.
11
Effects selector
-
Allows to select the effect from 1 to 8 :
Reverb Plate/ Plate2/ Room/ Room2/ Hall/ Hall2/ Delay/ Vocal doubler
12
Mounting plate
-
Allows you to insert a 35 mm tube to pole-mount satellites. One of the tubes of the supplied speaker stand can be
used to mount your satellites.
13
Channels 1 to 3 effect level
-
This setting allows you to adjust the level of effect of each channel to meet your needs.
14 - Channels sound level
Allows you to adjust the sound level of each channel.
This setting also affects the main volume level of the amplification system.
(PLEASE MAKE SURE TO CONFIGURE IT IN ORDER TO PREVENT THE LIMIT FROM BEING LIT)
15 - Channels 1 to 3 input selector
Allows you to choose the type of source connected to each channel.
Please make sure to properly configure the sound levels of your system. In addition to being unpleasant for
the audience, improper settings can damage your whole sound system.
The "LIMIT" indicators will light on when the maximum level is reached and must never be permanently lit.
CAUTION
Beyond this maximul level, the volume will not increase but will be distorted.
Moreover, your system can be destroyed by an excessive sound level despite of the internal electronic protections.
First, in order to prevent that, adjust the sound level via the Level of each channel.
Then, use the High/Low equalizer to adjust the acoustic as you wish.
Finally, adjust the volume of the subwoofer.
If the sound output does not seem powerful enough, we strongly recommend to multiply the number of systems in
order to spread the sound output evenly.
Page 6
®