- ページ 2

ヒーター Consort CSL2LSTのPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Consort CSL2LST 4 ページ。 Sl wireless controlled low surface temperature panel convector heaters
Consort CSL2LST にも：インストレーション＆コントロール・マニュアル (4 ページ)

ページを印刷する

General Safety

Our Low Surface Temperature heaters

have been designed and built to the

NHS requirement for safe surface

temperatures which is that no surface

which can be touched by the user will

be more than 43 ºC (at a room

temperature of 21 ºC) This means that

our Low Surface Temperature heaters

out-perform the European Standard by

a significant margin.

The appliance is not intended for use by

persons (including children) with

reduced physical, sensory or mental

capabilities or lack of experience and

knowledge unless they have been given

supervision or instruction concerning use

of the appliance by a person

responsible for their safety. Children

should be supervised to ensure that they

do not play with the appliance.

Safety Monitor

As part of the intelligent control (see

section 15), the heater has built-in safety

monitoring. In the unlikely event of a

fault, the safety monitoring will help

prevent high surface temperatures. The

safety monitor will identify overheating,

fan failure and certain electronic faults.

When the safety monitor identifies a

fault, the heater runs in restricted mode.

However, in the event of a serious fault

the heater stops running. The heater

indicates a fault by beeping twice. It will

not beep again until the unit is switched

off and then back on, but the LED will

flash red continuously.

Thermally Operated Cut-Out

The appliance is fitted with a thermally

operated cut-out (TOC). In the unlikely

event that the safety monitor fails, this

safety device will switch the heater off if

the appliance overheats. If the TOC has

tripped there is a high possibility the

heater is faulty and should be checked

by a qualified person. The TOC can only

re-set after the appliance has cooled

down, however we advise not to do this

until the heater has been checked

In order to re-set the TOC, proceed as

follows:

62001231 Iss 03

Switch off appliance and leave for

approximately 10 minutes.

Switch appliance back on and the

TOC will re-set.

Ensure that the appliance is

functioning correctly. If the TOC

control operates again, the

appliance should be checked by a

qualified person.

The heater carries a 'Do Not Cover' label to

warn the user that if the appliance is

covered, there is a risk of overheating.

Warning

Do NOT site the appliance in a corner.

Do NOT handle the appliance with wet

hands.

Do NOT use the appliance in workshops or

rooms where excessive dust is generated

or present.

Ensure that nothing is pushed into the air

outlet of this appliance.

Do NOT touch outlet grille when the

appliance is in use.

Do NOT cover or restrict the appliance

when in use.

Do NOT use the appliance if damaged.

Do NOT leave the appliance unattended

where young children are present.

This appliance must be earthed.

Intelligent Fan Control

The intelligent fan control incorporates one of

the latest low energy consumption EC

motors. This allows the heater to operate

quietly, whilst still providing the best possible

levels of comfort.

The intelligent fan control is only activated

when the heat is switched on. If the heater is

running in fan/boost mode only (heat

switched off), then the fan will operate at a

fixed speed.

When activated, the intelligent fan control

detects the temperature of the room.

Depending on which heat mode is

activated, it will calculate the best possible

airflow temperature and will adjust the fan

speed accordingly.

NOTE: When turning the heater on, or changing

heat mode or fan speed mode, the fan will

respond accordingly after a small time delay.