- ページ 4
コントローラー Belden Hirschmann iVISOR DS85のPDF 製品情報をオンラインで閲覧またはダウンロードできます。Belden Hirschmann iVISOR DS85 5 ページ。 Faceplate replacement
ページを印刷する9. Install the pushbutton board and the LED indicator board using the eight metal threaded standoffs provided
in the kit. (These replace the original standoffs; the old were male/female, the new are female/female).
(Figure H)
10. Reinstall the LCD Display board with the original Phillips screws. During installation, check the visibility of
the LCD display and ensure that it is clearly visible and free of any dirt or debris. Also verify that the long
connector is oriented as shown in figure F.
11. Reinstall the Main board using a 5 mm socket and Phillips screwdriver along with the original standoffs and
Phillips screws (figure E). Ensure that all plug-in connectors are seated properly.
12. Next, reinstall the Fuse / Connector board using a 5.5 mm socket and the original standoffs (figure D). Ensure
that all plug-in connectors are seated properly. Also, ensure that the shield located over the fuses is oriented
as shown below (figure J). If it is installed improperly, the assembly will not fit into the housing.
13. Reconnect the wiring (figure C).
(Figure J)
Hirschmann Automation and Control
1540 Orchard Drive
Chambersburg, PA 17201
Document: 530117 - DS85 Faceplate Replacement
Service : (717) 217-2250
Parts / Sales : (717) 217-2269
www.hirschmann-usa.com
Page 4 of 5