- ページ 2

ストレージ Addonics Technologies ST45HPMXA-BのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Addonics Technologies ST45HPMXA-B 8 ページ。 Storage tower

1. Open the outer cabinet by removing the two screws securing the

side panels, then pushing each side panel toward the rear of the

unit.

2. Mount up to two 5.25" devices or enclosures using the supplied

screws.

3. Connect each device or each connection on each enclosure to the

Port Multiplier.

4. Close the outer cabinet and secure it with the three cover screws.

5. If multiple drives in the cabinet are to be used independently,

connect the eSATA port on the back of the unit to an eSATA host

that supports Port Multipliers or connect USB 3.0 port. Do not

connect USB and eSATA concurrently.

6. If multiple drives are installed and a RAID configuration is desired,

proceed to the section titled Configuring the RAID Mode. If a

single RAID unit is created, port multiplier support is not required.

If multiple RAID units are defined, an eSATA host that supports

Port Multipliers will be required.

Cover Screw

www.addonics.com

Installation

eSATA port

Dipswitch

Technical Support (M-F 8:30am - 6:00pm PST)

Cover Screw

Set Button

Phone: 408-453-6212

Email: www.addonics.com/support/query/