- ページ 3

キャッシュカウンター Cassida 6600のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cassida 6600 3 ページ。 Feed gap procedure
Cassida 6600 にも：洗浄手順 (3 ページ)

4. Gently tug on the end of each bill. There should be moderate resistance.

IMPORTANT: The left and right bills sho, uld have equal resistance.

Technical Services for further troubleshooting. Be sure to provide the following information:

a. If the bills feel too loose, tighten the feed gap by turning the adjustment screws counterclockwise with

Phillips screwdriver.

b. If the resistance feels too tight, loosen the gap by turning the screws clockwise with Phillipʼs screwdriver.

c. Adjust 1/8 turn at a time, then reconnect the power cord and turn the unit on. Retest the unit to see if it works

fine or it needs more feed gap adjustment.

Feeding gap

adjusting screw. (left)

Feeding gap

adjusting screw. (right)

NOTE:

Several factors can cause a Cassida 6600 to jam or not recognize

genuine bills:

- Overly wrinkled, overly creased, overly worn, and vandalized bills

- Foreign objects dropped or run through the bill path

- Dropping the unit or bumping into the unit during use

- A harsh change in temperature

- Extended period of non-use

- Improper maintenance or lack of preventative maintenance/cleaning

Cassida Corporation • 11035 Technology Place, Suite 500 San Diego, CA 92127 • www.CassidaUSA.com

Feed Gap Procedure

CONTACT INFORMATION

Cassida Corporation

After Market Technical Services

Support: http://www.cassidausa.com/support

6600

Bills feel tight, loosen

feed gap (clockwise)

Bills feel loose, tighten

feed gap (counterclockwise)

REV0919