- ページ 10

スパ・アクセサリー Aeware in.zoneのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aeware in.zone 14 ページ。 Innovative corona discharge ozonator

in.zone

Ozone injection system

Ozone ready spa:

Follow the manufacturer's instructions to

install in.zone on an ozone ready spa.

Non ozone ready spa:

A- To install with an injection manifold (bypass)

* Manifold and Venturi can be purchased at spa dealers stores.

A1- Follow the safety instructions listed at the beginning

of this manual.

A2- Cut a section of 1 1⁄ 2 " plumbing after the ﬁ lter, pump and

heater. You should install the manifold (bypass) as far as

possible from the spa tub. The longer the tube is between the

Spa

water flow

Filter

Pump

Heater

injection point

venturi

valve

bypass and the spa the better because it gives time and space

to ozone to mix with water. We recommend to have at least

10' of tubing between the injection point and the spa tub.

Attention: It is important that ozone do not pass through the

heater or ﬁ lter

A3- Install the injector manifold with a bypass purchased at a spa

dealer store (the kit should include the venturi).

A4- Connect in.zone so you are sure it will be activated when

pump is working and at its lowest speed (if it is a 2 speed

pump).

A5- Don't forget to perform a suction test before powering

up in.zone (refer to suction test page 11).

hartford

loops

check

valve

air flow

bypass (manifold & venturi)

installation

check

valve