- ページ 2

配管製品 Durastall 142のPDF 組立、設置、補修部品をオンラインで閲覧またはダウンロードできます。Durastall 142 6 ページ。 Shower stall

Suspend Center Panel off floor. Angle Corner Lock Strip

slightly, and engage a short section of Center Panel into Lock

Strip channel making sure smooth (gloss) side of panel will be

on inside of shower stall. Align top edge of Corner Lock Strip

with top edge of Center Panel. After total length of Lock

Strip has been started, secure the strip by tapping from top

to bottom with a mallet or hammer handle. Repeat

procedure for remaining Lock Strip. (FIG. 1)

Before installing Safety Rail, place a "U" nut on each end

of Safety Rail making sure flat surface is on outside as shown.

Position Safety Rail inside cabinet so that each end is

located between the two ribs on the inside of the front support

extrusions. Use a #10 x 5/8" Truss Head Screw to secure

both ends of the Safety Rail through the pre-punched holes in

the front supports. Position side and rear mounting pods of

Safety Rail onto previously installed mounting screws. Place a

1/4"-20 Flanged Nut on each mounting screw and tighten

securely using a 7/16" wrench. (FIG. 4)

BEFORE PROCEEDING TO STEP 5, POSITION BASE IN

PERMANENT LOCATION — SEE BASE INSTRUCTIONS

Suspend Right Side Panel and Center Panel Assembly off

floor. Working from outside, angle Center Panel Assembly

slightly to start engagement. Engage a short section of the

Side Panel and align so that top edge of panel is even with

the top of the Corner Lock Strip. After total length of Locking

Strip has been started, secure the strip in place by tapping

from top to bottom. Repeat procedure for Left Side Panel.

(FIG. 2)

FIG. 2

Insert a 1/4"-20 Flat Head Machine Screw through the hole

in molded Safety Rail Washer. Note that there are two holes

punched in the center of each panel. Screw a washer/screw

assembly into each hole from outside as shown.

Do not overtighten! (FIG. 3)

FIG. 3

FIG. 1

FIG. 4

SI-188 (8•07)