- ページ 9
カーエレクトロニクス Audiotechnik Dietz 66010のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Audiotechnik Dietz 66010 13 ページ。 Interface can bus
ページを印刷する
Assignment of the wires with loose ends (Interface)
Red
Constant power
Black
Ground
Green
CAN - High
White
CAN - Low
Pink
Grey
Alternative second output for further signals – programming necessary!
Orange
If you use this output then you loose one of the other outputs!
Examples:
Possibilities:
Pink
(max. 1,5 A)
Grey
Orange
(max. 0,1A)
Installation
Interface 66012 was developed to get different signals out of the CAN Bus of the car. The interface read out
the signals for ignition, illumination, reverse gear, speed, parking sensors, hand brake and mute for Blue & Me
systems.
Self-Recognition
The selection of the protocol comes through SELF-RECOGNITION. After connections for inserting the module
to the connector are terminated, the unit will undertake the synchronization in a few seconds, signal led by
RED quick flashes of the module's LED.
As soon as the synchronization has been completed, the protocol of the vehicle must be selected. This
operation will be confirmed if the GREEN LED of the module is on.
Function setting
To change the output signal be sure that the interface is complete installed in the car. Connect the cables of
the Interface with the cables of the car. The LED must be green permanent.
To change the output from ignition to anything else please follow this example:
Example:
Change
Output 1 (pink cable) to "Positive output 12 Volt below 10 km/h (Function 14) and
Output 2 (orange cable) to "Reverse gear" (Function 3)
1. Output Ignition – default
2. Output Speedsignal – default for second output
Default
Ignition or
Rear Gear or
Ignition
Illumination or
Hand brake
Speed
-
ONLY 2 SIGNALS CAN BE USED !
Copyright © by Audiotechnik Dietz
Rear Gear or
Illumination or
Hand brake
Speed
-
12 V < 10km/h
Vertriebs-GmbH ● Germany
®
Rev 6, Stand: 2 / 2018
Ignition or
Ignition or
Rear Gear or
Illumination or
Hand brake
-
Ignition or
Rear Gear or
Illumination or
Hand brake, if not
already choosen for
9
-
output 1!