- ページ 10

ゲートウェイ 3xLogic infinias eIDC32のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。3xLogic infinias eIDC32 17 ページ。

CONFIGURE THE eIDC WITH THE WEB SERVER

The eIDC has a built-in server which allows a Web browser to connect

to the eIDC.

IMPORTANT: If static addressing is to be used, you must obtain a valid

static IP Address, Subnet Mask, and Gateway from the network

administrator of the facility where the eIDC is located. You will need this

information to change the eIDC default static IP address (169.254.1.1).

1. Open a standard Web browser.

2. Type the IP address given by the eIDC (DHCP or static) into the

address bar of the browser to locate and configure the eIDC, and

then press Enter. The infinias Web Edition screen appears.

3. Click the "Click Here to Start" button. The login screen appears.

4. Type admin (all lowercase) in the user name and password text

boxes (admin is the default value for both of these fields). NOTE:

If the user name and password have been are unknown, you will

need to reset the eIDC to its factory default settings. Refer to the

installation manual included on the resource disc.

1. Click the System button, and then click Controllers.

2. Select the eIDC controller, and then click the Modify button.

3. Select the IP mode: DHCP or static

a. DHCP: Verify that the Use DHCP check box is selected; DHCP

is the default setting. For more information on DHCP

addressing, refer to the installation manual included on the

resource disc.

b. Static: Click the Use DHCP check box to clear the selection,

and then type the new IP Address, Subnet Mask, and Gateway.

4. Click "OK," and then click "Done" to save the changes. The eIDC is

now ready for further configuration and use.

5. Go to

the installation.

Wire the eIDC Door Components

on page 11 and complete

QSG-002 / 01-03-2017