ページを印刷する
Step 1: Position Door Track (107) on front wall 55mm
down from underside of Roof, with left hand
end flush with the left hand door jamb. Pre-drill
hole in centre and rivet in place. Remove ALL
drill filings
Step 2: Hang door in Door Track. At the right hand
end of Door Track, adjust up or down so that
the Door hangs parallel with shed. Fit one
rivet at right hand end to hold in place. Repeat
with left hand end of track.
Step 3: Remove Door. Pre-drill holes into each Rib
and at similar spacings into Over Door Flash-
ing. At approximately 1/3 in from each end of
Door Track put a 50mm nail. Fix rivets to rest
of holes
Step 4: Clean out ALL drill filings. Also make sure
the Wheels are cleaned of drill filings. Re-
hang Door, then insert door stops into the
pre drilled holes at end of tracks as shown in
diagram. Tighten with two spanners.
KL3 DOOR
11
Nut
Washer
Aluminium
Door Stop
55
Door Track
Washer
Bolt