- ページ 12

バッテリーチャージャー APLIC 20180528SZ137のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。APLIC 20180528SZ137 16 ページ。 2-bay battery charger

4.1 Key functions

Connection

When power adapter

is connected

Without power

adapter

5. Power supply

Use only a power supply, which meets the specifications of this device (DC 12V /

3A). Pay attention to the correct polarity of the contacts. Please also bear in mind

that the maximum charging current depends on the capacity of the power supply.

6. Setting up

Take the device out of the package and remove all the packaging material. Plug the

supplied power adapter to a properly installed power socket and to the battery

charger. You can then insert the desired type of battery into the charger.

Caution! Charge only rechargeable batteries. Please do not use non-rechargeable

batteries!

Various data such as the actual voltage and the charging status is shown in the

display as soon as a battery is inserted. The actual charging current is shown at the

bottom of the display. This can be adjusted between 500mA and 2000mA. Press

and hold the "MODE" button to configure the current until the selection arrow

starts to flash over the current. Then, you can adjust the current by briefly pressing

the "MODE" button. The corresponding current is enabled once the arrow stops

flashing.

"MODE" key

Function

keep it pressed

Current setting

• Alternates between voltage dis-

press briefly

• During current setting, changing

Switch on Powerbank function (only

press briefly

possible with at least one Li-ion

battery in place!)

play and percentage display

the charging current

English