- ページ 7

アクセサリー 4CR FY-3CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。4CR FY-3C 12 ページ。 Shortwave infrared curing lamp

ページを印刷する

1.Automatic Mode

a. Properly assemble the curing system according to the instruction (see page 3).

b. Switch on the power supply. The display will go through the start-up procedure and

automatically default to Automatic Mode. The system is ready to use when the

parameters appears on the display screen as follows:

Move forward or backward heat lamp to adjust to the best distance.

Distance data will be detected and displayed on the screen.

Roast lamp lamp holder and paint surface distance according to the paint

material and weather conditions to adjust the humidity of the (air humidity).

Under normal circumstances,Advised to keep distance from 35 to 45 cm.

d. Press the button "Start/Stop" to start automatic curing mode. Once the automatic

mode is selected, Four related cure programs become available to the user – Program

1-4(Fig. A).

Pulse Time (3min)

step1

Power (

Routine Time (

step2

Power (

Pulse Time (3min)

step3

Power (

Routine Time (

step4

Power (55%)

e. Protect the lamp against shocks and vibrations when the lamp is in use.

g. After this program is completed, the system is able to carry out other programs. Make

sure to turn off the system when the equipment is not in use and keep the equipment

securely in place.

5. Operation

during execution, but it won't change the default data.

Fig. A

mode, adjust the parameters as follows before pressing

"Start":

automatically defaults to Step 1 of the automatic mode.

min)

again, switches to Step 3; keep pressing, switches

recurrently.

power by Button 2 and 4, stay unchanged for 3 seconds

then the data will be automatically saved as default

min)

setting for this step.

adjustment buttons + and - at the same time.

00:00

100

050

The time and power of each step can be adjusted

If you want to change the default data of automatic

1). Once switching on the power supply, the display

2). Press "Routine" once, switches to Step 2; press

3). When switch to each step, adjust the time and

4) To initialize all data, press and hold the distance

Time to adjust

Distance adjustment

Power adjustment

Page 5