4CR FY-3C Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары 4CR FY-3C. 4CR FY-3C 12 страниц. Shortwave infrared curing lamp

Печатать страницу
4CR FY-3C Руководство по эксплуатации
1.Automatic Mode
a. Properly assemble the curing system according to the instruction (see page 3).
b. Switch on the power supply. The display will go through the start-up procedure and
automatically default to Automatic Mode. The system is ready to use when the
parameters appears on the display screen as follows:
c.
Move forward or backward heat lamp to adjust to the best distance.
Distance data will be detected and displayed on the screen.
Roast lamp lamp holder and paint surface distance according to the paint
material and weather conditions to adjust the humidity of the (air humidity).
Under normal circumstances,Advised to keep distance from 35 to 45 cm.
d. Press the button "Start/Stop" to start automatic curing mode. Once the automatic
mode is selected, Four related cure programs become available to the user – Program
1-4(Fig. A).
Pulse Time (3min)
step1
Power (
Routine Time (
step2
Power (
Pulse Time (3min)
step3
Power (
Routine Time (
step4
Power (55%)
e. Protect the lamp against shocks and vibrations when the lamp is in use.
g. After this program is completed, the system is able to carry out other programs. Make
sure to turn off the system when the equipment is not in use and keep the equipment
securely in place.

5. Operation

during execution, but it won't change the default data.
Fig. A
mode, adjust the parameters as follows before pressing
"Start":
%)
70
automatically defaults to Step 1 of the automatic mode.
5
min)
%)
65
again, switches to Step 3; keep pressing, switches
recurrently.
%)
60
power by Button 2 and 4, stay unchanged for 3 seconds
then the data will be automatically saved as default
5
min)
setting for this step.
adjustment buttons + and - at the same time.
00:00
100
050
The time and power of each step can be adjusted
If you want to change the default data of automatic
1). Once switching on the power supply, the display
2). Press "Routine" once, switches to Step 2; press
3). When switch to each step, adjust the time and
4) To initialize all data, press and hold the distance
Time to adjust
Distance adjustment
Power adjustment
Page 5