- ページ 14

リフティングシステム APlusLift MT1500XのPDF 設置マニュアルと操作説明書をオンラインで閲覧またはダウンロードできます。APlusLift MT1500X 20 ページ。 Motorcycle lift

I nst a lla t ion

4 .

4.6 SIDE EXTENSION INSTALLATION ( APlusLift MT1500X)

The side extensions for the APlusLift MT1500X are easily installed. There are 4 extension tubes

provided for installation which also includes 1 stabilizing bar. The 2 short extension tubes are

slid into the holes on the back of the table assembly at the opposite end of the vise by the rear

approach ramp. You must secure the short extension tubes to the table assembly by

securing and tightening 1 screw in each tube under the table to lock them in place once they

are installed. The long extension tubes run all the way through, underneath the front side of

the table assembly and also in front of the drop out tail on some models.

You must remove both end caps, slide the stabilizer bar through the square holes on the rear

locking scissor legs and then reattach the end caps to the stabilizer bar. Slide the 2 extensions or

tool trays over the tubes and insert the quick pins in the appropriate holes at the end of the round

tubes to secure the table extensions to the lift. For the approach ramp, use the provided bolts and

nuts to secure the ramp extensions onto the approach ramp on each side.

Please see the pictures below for proper installation of the side extensions & tool trays.

NOTE: ALWAYS ensure that the load lifted is on the center line of the table in line with the

center of the front vise and the rear drop out tail.

2 Long Extension Bars

NOTE: YOU CAN INSTALL

THE SIDE EXTENSIONS

TURNED 180

THEM AS TOOL TRAYS!

2020

2 Short Extension Bars

AND USE

Phone: 800-616-9618 Text: 425-300-2600 Email: [email protected]

www.apluslift.com

APlusLift MT1500 & MT1500X

I N ST ALLAT I ON M a nua l

6 Quick Pins

SAFET Y LOCK

LAT CH BAR

14 of 20