- ページ 10
おもちゃ Apogee Black Brant VCのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Apogee Black Brant VC 16 ページ。
40. Holding the rail guide by impaling it on the end
of a pin, saturate the entire rail guides with thin
CyA adhesive to harden the surface. Set the rail
guides aside to allow the adhesive to set com-
pletely prior to attempting to remove them from the
needle. Once dry, lightly sand the surface smooth
with fine sandpaper.
Final Assembly:
41. Route the shock cord back into the motor
mount tube so that it is stored properly within the
tube. Cut out the fin marking guide, and wrap it
around the main body tube. A specific alignment of
the lines with regard to the motor mount is unnec-
essary and any alignment is entirely aesthetic.
Mark the locations and extend them along the en-
tire length of the main tube using an extruded alu-
minum angle or doorframe to maintain alignment.
All position marks in the remaining steps are
referenced from the aft end of the main 29mm
body tube (not the motor mount tube).
42. Mark the position of the motor band at 3/4"
(19mm) from the aft end of the main body tube.
Using the marking guide as a straight edge, draw
a line all the way around the tube to provide a
guide for the wraps.
43. Mark the position of the forward rail guide at
12-5/8" (322 mm) from the back end of the main
body tube. Also mark the position of the launch lug
at 4-3/4" (121 mm) from the aft edge of the body
tube.
44. Mark the position of the canards. They fall on
the same lines as the main fins, only further down
the tube. The canards on opposite sides of the
tube are at slightly different positions. Mark one
pair at 13-1/2" (343mm) and the second pair at
13-11/16" (347mm) from the back end of the main
body tube.
Page 10
Step 40
Step 41
Future Measurements
are from This Point
Step 42
3/4" (19mm)
Step 43
Step 44