- ページ 3

クロスオーバー APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVERのPDF オーナーズマニュアルとセットアップ説明書をオンラインで閲覧またはダウンロードできます。APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER 9 ページ。

FULL RANGE APOGEE/SCINTILLA ACTIVE CROSSOVER

Setting the crossover networks and two-way or three-way operation will be performed

at the factory if the system configuration is specified in advance of purchasing

the crossover.

If it is desired to perform the changes in the field then this may simply be

accomplished by setting the rocker switches.

The active crossover rocker switches are located inside the active crossover.

To set the rocker switches the following procedure should be followed.

a. Unplug the active crossover power plug.

b. Unscrew the top plate.

c. For the two-way operation push the top rocker switches C1 and C3.

(See Figure.1)

For three-way operation push the top rocker switches C2 and C4.

d. Large Full Range Apogee frequency shaping network insertion requires pushing

the bottom rocker panel switches C1 and C3.

e. Scintilla two-way operation and frequency shaping network insertion requires:

1. Top Rocker Switch – push C1 and C3.

2. Bottom Rocker Switch – push C2 and C4.

Top Rocker Switches

Bottom Rocker Switches

FIGURE 1

C1 and C3 pushed = 2 way

C2 and C4 pushed = 3 way

C1 and C3 pushed = Large Full

Range Apogee

C2 and C4 pushed = Scintilla

(Page 2)