- ページ 13

計測機器 Apogee Instruments MQ-210のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Apogee Instruments MQ-210 18 ページ。 Underwater quantum meter

When a quantum sensor that was calibrated in air is used to make underwater measurements, the sensor reads low. This

phenomenon is called the immersion effect and happens because the refractive index of water (1.33) is greater than air

(1.00). The higher refractive index of water causes more light to be backscattered (or reflected) out of the sensor in water

than in air (Smith,1969; Tyler and Smith,1970). As more light is reflected, less light is transmitted through the diffuser to the

detector, which causes the sensor to read low. Without correcting for this effect, underwater measurements are only relative,

which makes it difficult to compare light in different environments.

The MQ-210 sensor has an immersion effect correction factor of 1.08. The immersion effect correction factor is already

accounted for in the MQ-210 meter firmware so there is no need to apply the correction factor to your measurements. If you

wish to use your meter to make measurements in air, simply divide the measured number by the immersion effect (1.08).

When making underwater measurements, only the sensor and cable can go in the water. The handheld meter is not

waterproof and must not get wet. If the meter might get wet from splashing, we recommend placing it in a plastic bag or

other container to help protect it from accidentally getting wet.

Further information on underwater measurements and the immersion effect can be found at

http://www.apogeeinstruments.com/underwater-par-measurements/.