- ページ 3

GPS Appareo STRATUS ESGのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Appareo STRATUS ESG 5 ページ。 Portable receiver connector plate
Appareo STRATUS ESG にも：パイロット・マニュアル (13 ページ), マニュアル (9 ページ)

ページを印刷する

This document is intended to help you determine the best method for installing the Stratus ESG

connector plate in an aircraft and connecting it to a portable ADS-B In receiver.

Supplied Components

9 Pin D-Sub Connector with mounting hardware

BNC Connector

BNC-BNC Connector

Connector Plate

Additional Components

•

RF cabling: RG 400 (Stratus ESG to connector plate RF connector)

•

D-Sub cabling: 20 AWG wire (Stratus ESG to connector plate D-Sub)

Tools needed

•

Screwdriver

•

Retaining ring pliers

•

Standard wrenches

Installing the connector plate

1. Mount the connectors onto the connector plate, as shown in the diagram above.

NOTE: The D-Sub and BNC-BNC connector are mounted to the connector plate. The

BNC connector and retaining ring are installed onto the transponder backplate.

2. Find a location to secure the connector plate within the maximum cable length of 3 feet.

The connector plate measures approximately 1.5" x 3" and can be secured in any

orientation in any available space in the cockpit. Orient the connector plate so that the

Stratus logo is visible and readable.

Document Number: 600890-000054

Stratus ESG to Portable Receiver Connector Plate Installation Guide

Installing the connector plate

Part Name

Last Revised: April 27, 2016

Appareo Part

Quantity Needed

Number

251015-000094

251015-000078

251015-000089

353070-000043

Revision 1.2

Page 3 of 5