- ページ 15

ジャックス DURHAND C20-048V00のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DURHAND C20-048V00 18 ページ。 Electric car jack kit

Operation

1. Turn on the power of the car.

2. Plug into cigarette lighter or connect with the car battery.

3. Choose the proper socket to the wrench's shaft (Fig.1).

4. According to the thread direction, press the switch for tightening or loosening (do

the reverse for L.H screw) (Fig. 2 ).

5. Press the left side of the switch (with mark II) to start. Each nut will be lose after

hearing the 'clatter' 2-3 times.

Note: If the wrench pins without impacting, start the engine at the maximum volt-

age.

6. Press the right side of the switch (with a mark) to tighten nuts - it will be tight

enough after hearing the 'clatter' sound 2-3 times.

Apply the wrench to the wheel nut, then press the

upper side of the switch (marked 'L'). The nut will

loosen . Press the upper side of the switch (marked

'T') and the nut will tighten.