- ページ 4

バッテリーチャージャー Durite 0-647-31のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Durite 0-647-31 5 ページ。 6/12v 1a digital battery charger

1. Automatically enter float mode

The charger will enter float mode automatically when finished charge to prevent

overcharge.

2. DC input short-circuit protection

The charger will shut down automatically when DC input short-circuit.

3. Over-temperature protection

The charger will shut down in two situations as below, and it will enter charge

mode automatically when temperature recovers to the normal condition.

a. When charger used long time under high temperature.

b. When inside temperature of charger reaches the present temperature.

4. Over-voltage protection

5. Fire protection

There is no output in the clamp when disconnected with battery.

6. Low-voltage activation

The charger will enter the charge mode automatically when voltage of end of

clamp was higher than DC 2V, the charger will not output if voltage is lower than

DC 2V.

TROUBLESHOOTING

No reaction when power is on:

1. Check the battery charger is plugged into the socket and makes a good connection

2. AC socket whether has AC output?

3. Send the charger to professional person to test

Power indicator light but no AC output:

1. Check the clip is connected well

2. Check the terminal for corrosion

3. Check the wire of the clip to see if broken

4. Send the charger to professional person to test

Power indicator and fault indicator light at the same time:

1. Check clips to see if they are connected round the wrong way

2. The charger was on over-temperature protection

3. Check to see if wrong voltage of battery selected

4. Send the charger to professional person to test

Power indicator not illuminated when charger is working

Faulty LED indicator

6V or 12V indicator not illuminated when charger is working

Faulty LED indicator

6V/12V can't switched or not sensitive

1. The operation is improper when using the switch

2. Switch was damaged

0-647-31-LEAF