Durite 0-647-31 Manual - Page 4
Browse online or download pdf Manual for Battery Charger Durite 0-647-31. Durite 0-647-31 5 pages. 6/12v 1a digital battery charger
Print Page
1. Automatically enter float mode
The charger will enter float mode automatically when finished charge to prevent
overcharge.
2. DC input short-circuit protection
The charger will shut down automatically when DC input short-circuit.
3. Over-temperature protection
The charger will shut down in two situations as below, and it will enter charge
mode automatically when temperature recovers to the normal condition.
a. When charger used long time under high temperature.
b. When inside temperature of charger reaches the present temperature.
4. Over-voltage protection
5. Fire protection
There is no output in the clamp when disconnected with battery.
6. Low-voltage activation
The charger will enter the charge mode automatically when voltage of end of
clamp was higher than DC 2V, the charger will not output if voltage is lower than
DC 2V.
TROUBLESHOOTING
No reaction when power is on:
1. Check the battery charger is plugged into the socket and makes a good connection
2. AC socket whether has AC output?
3. Send the charger to professional person to test
Power indicator light but no AC output:
1. Check the clip is connected well
2. Check the terminal for corrosion
3. Check the wire of the clip to see if broken
4. Send the charger to professional person to test
Power indicator and fault indicator light at the same time:
1. Check clips to see if they are connected round the wrong way
2. The charger was on over-temperature protection
3. Check to see if wrong voltage of battery selected
4. Send the charger to professional person to test
Power indicator not illuminated when charger is working
Faulty LED indicator
6V or 12V indicator not illuminated when charger is working
Faulty LED indicator
6V/12V can't switched or not sensitive
1. The operation is improper when using the switch
2. Switch was damaged
0-647-31-LEAF
www.durite.co.uk