- ページ 5

コントロールユニット APPENDIX SCE 2000のPDF マニュアルをオンラインで閲覧またはダウンロードできます。APPENDIX SCE 2000 8 ページ。 External optical bypass module

Appendix A

The External Optical Bypass Module

How to Cable the External Optical Bypass Module

The following procedure describes how to cable the External Optical Bypass module. Note the

following:

•

Figure A-4

Step 1

Connect an optical cable (user supplied) between the GBE port on the Subscriber side network element

and the SUB port on the External Optical Bypass module.

Connect an optical cable (user supplied) between the GBE port on the Network side network element

Step 2

and the NET port on the External Optical Bypass module.

Verify that the links between the two network elements are active.

Connect the SUB cable of the fiber of the External Optical Bypass module to the SUB GBE port of the

Step 3

SCE 2000 platform.

Rx<->Tx

Connect the NET cable of the fiber of the External Optical Bypass module to the NET GBE port of the

Step 4

SCE 2000 platform.

Rx<->Tx

OL-21096-02

All connections to the External Optical Bypass module are on the front panel of the module

(Figure

A-4).

If installing only one module, the connections are as follows:

Connect the fiber (steps 3 and 4) to the GBE-1 Line ports on the SCE 2000 platform.

–

Connect the control cable to the Bypass 1 9-pin D-Type connector on the rear panel of the SCE

2000 platform.

If installing two modules, repeat the entire procedure for the second module, with the following

changes:

Connect the fiber (steps 3 and 4) to the GBE-2 Line/Cascade ports on the SCE 2000 platform.

–

Connect the control cable to the Bypass 2 9-pin D-Type connector on the rear panel of the SCE

–

2000 platform.

SCE 2000 Rear Panel Bypass Connectors

BY PA SS

PO W ER B

PO W ER A

Cisco SCE 2000 4xGBE Installation and Configuration Guide

Installing the External Bypass Module

A-5