- ページ 14

ミシンアクセサリー DURKOPP ADLER 867のPDF 補足説明をオンラインで閲覧またはダウンロードできます。DURKOPP ADLER 867 20 ページ。 Remaining thread monitor
DURKOPP ADLER 867 にも：取扱説明書 (16 ページ), 使用方法 (4 ページ), 取扱説明書 (16 ページ), 取扱説明書 (8 ページ), 補足説明 (18 ページ)

ページを印刷する

6. Assemble the compressed air maintenance unit (5) to the stand.

7. Use an R 1/4" hose coupling to connect the connection hose to

8. Set the operating pressure to 6 bar.

9. Connect the hose (6) to the valve (7).

2.3 Setting the remaining thread monitor electrically

Important

The remaining thread monitor is delivered with a basic setting.

As a rule, the sensitivity of the residual thread monitor does NOT have

to be set!

The pre-set sensitivity of the remaining thread monitor may only be

changed if the remaining thread monitor is not working properly.

Fig. 9: Setting the remaining thread monitor electrically

(1) - Plug connection light barrier,

(2) - Plug connection light barrier,

(3) - Plug connection inputs and outputs

After the machine has been switched on and before it starts sewing, the

remaining thread monitor is in setting mode.

To set the remaining thread monitor:

1. Switch on the machine.

2. Insert an empty bobbin into the hook.

3. Turn the hook to a position that the light beam falls through the slot in

4. Set the potentiometer (5) or (7) to the highest sensitivity.

the compressed air supply.

③

②

①

right hook

left hook

of the control

the hook housing onto the bobbin.

To do this, turn the potentiometer clockwise.

Assembling the remaining thread monitor

④

(4) - Plug connection switched output

(5) - Potentiometer left hook

(6) - LED

(7) - Potentiometer right hook

(8) - Plug connection auxiliary output

Additional Instructions 867/867-M PREMIUM - 00.0 - 07/2018

⑤⑥

⑦ ⑧