- ページ 4

計測機器 4iiii PM100のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。4iiii PM100 9 ページ。 Power meter
4iiii PM100 にも：クイック・スタート・マニュアル (2 ページ)

1.2.1 Pod Placement

Locate a flat area on the inner face of the crank arm for

installing the Precision

power meter pod. There should

be a minimum of 40 mm or 1 5/8 inches between the pod

location and the pedal spindle.

Do not place the pod over uneven surfaces,

decals, stickers, rivets, or screw holes on the

crank arm. Doing so will interfere with the

accuracy of the power meter.

1.2.2 Using Installation Tool and Installation Band

Place and hold the metal plate of the Precision

the crank arm as shown in section 1.2.1 and secure the pod

on the crank arm using the provided installation tool and

installation band.

Pull the installation band around the crank arm and attach

them to the hooks on the pod.

Slide the installation tool under the band and fix the pod in

place with the installation tool.

pod on

Figure 1.3

Figure 1.4

Figure 1.5

1.2.3 Clearance Check

With the Precision

pod fixed onto the crank arm as shown

in section 1.2.2, slowly and carefully rotate the crank arm 1

full revolution to ensure there is no interference between the

pod and any part of the bicycle frame.

Figure 1.6

If the pod interferes with the frame or any

other components on the bicycle, do not

proceed further with the installation. Contact

your retailer for assistance. If your pod was

purchased directly from 4iiii Innovations,

contact 4iiii online at

software-and-documentation.