ページを印刷するFIRST USE
Upon first use, there may be a trace of smoke or odour when the heater is
switched on. This is normal and will fade away quickly.
TURNING THE HEATER ON
1. Connect the Power
Place the heater on a flat dry surface, within close proximity to a mains plug
socket. Plug in the power cable and switch it on at the plug.
This heater is NOT suitable to be used on long pile carpets.
2. Switch on the Heater
Turn on the power switch on the
bottom of the heater. The Power/
Standby button will light up.
Press the Power/Standby button
to turn the heater on; by default the
heater will start to run at the lower heat
level (900W).
The Standby button and Setting I
button will be lit up.
Note: An audible beep can be heard when any button is pressed.
3. Switch on the Heater
To increase to the higher heat level (1500W), press the Setting II button.
Operating Instructions
6
2h
4h
1h
8h
Timer
Setting II
(1500W)
Setting I
(900W)
Power/Standby