Duronic FH15K 매뉴얼 - 페이지 6

{카테고리_이름} Duronic FH15K에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duronic FH15K 11 페이지.

FIRST USE

Upon first use, there may be a trace of smoke or odour when the heater is

switched on. This is normal and will fade away quickly.

1. Connect the Power

Place the heater on a flat dry surface, within close proximity to a mains plug

socket. Plug in the power cable and switch it on at the plug.

This heater is NOT suitable to be used on long pile carpets.

2. Switch on the Heater

Turn on the power switch on the

bottom of the heater. The Power/

Standby button will light up.

Press the Power/Standby button

to turn the heater on; by default the

heater will start to run at the lower heat

level (900W).

The Standby button and Setting I

button will be lit up.

Note: An audible beep can be heard when any button is pressed.

3. Switch on the Heater

To increase to the higher heat level (1500W), press the Setting II button.

Operating Instructions

Timer

Setting II

(1500W)

Setting I

(900W)

Power/Standby