- ページ 15

無線アクセスポイント 4IPNET EAP210のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。4IPNET EAP210 15 ページ。 Enterprise access point
4IPNET EAP210 にも: ユーザーマニュアル (20 ページ)

4IPNET EAP210 クイック・インストール・マニュアル
 Click on the Wireless button on the main menu.
 Select the Repeater tab.
 Choose WDS as the Repeater Type.
 Choose the desired RF card and WDS profile:
(a) Enable WDS.
(b) Enter the MAC Address (peer AP) and then Click SAVE.
If you are using another EAP210 as the peer AP, simply repeat the above-mentioned steps to configure
another peer AP(s).
On each and every configuration page, you may click SAVE to save the changes of your configured
settings, but you must reboot the system for the changes to take effect. After clicking SAVE, the
Note:
following message will appear: "Some modifications have been saved and will take effect after
Reboot."
Congratulations!
Now, 4ipnet EAP210 is installed and configured successfully.
After EAP210's network configuration is completed, please remember to change the IP Address of
your PC Connection Properties back to its original settings in order to ensure that your PC functions
properly in its real network environments.
It is strongly recommended to back up your configuration settings.
For further configuration and information, please refer to the User's Manual.
Copyright © 4IPNET, INC. All rights reserved.
EAP210 Enterprise Access Point
11
Quick Installation Guide
ENGLISH
P/N: V10020140917