- ページ 13
無線アクセスポイント 4IPNET EAP210のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。4IPNET EAP210 15 ページ。 Enterprise access point
4IPNET EAP210 にも： ユーザーマニュアル (20 ページ)
ページを印刷する
Step 3. Configure VAP (Virtual Access Point) Profile Settings
The EAP210 supports up to 16 virtual APs (VAPs).
Configure VAP profile settings：
(a) Select the VAP Configuration tab to configure the settings of the desired VAP.
(b) Choose a specific RF card to set up
(c) Enable a selected VAP from the drop-down menu of Profile Name and configure related
settings below.
Check "CAPWAP Tunnel Interface" if you would like data of this VAP to go through the
(d)
Controller when the Access Point is managed by CAPWAP.
Check VAP status：
After finishing VAP configuration, the status of the enabled Virtual APs shall be reflected on the VAP
Overview page – at Wireless > VAP Overview.
Copyright © 4IPNET, INC. All rights reserved.
VAP Configuration Page (RF Card A : VAP-1 shown)
EAP210 Enterprise Access Point
9
Quick Installation Guide
ENGLISH