- ページ 14

スイッチ Datacom Systems 4X16SP-1000BTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Datacom Systems 4X16SP-1000BT 20 ページ。 Copper gigabit span switch
Datacom Systems 4X16SP-1000BT にも：仕様書 (1 ページ)

ページを印刷する

play status of each port. See Table 2 for LED display. The NETWORK

PORT LED illuminates indicating link has been established between the

NETWORK PORT connector and network device SPAN port.

!! NOTE: The monitor tool has to match the selected network speed and duplex !!

Left LED — Notch Up

Solid Green — Link

Flashing Green — Data

Green — 1,000 Mbs

Orange — 100 Mbs

OFF — 10 Mbs

Left LED — Notch Down

Table 2 - LED Display

Step 3. Connect the COMMON A PORT of the 4X16SP-1000BT RJ45 connector to

the network tool Network Interface Card (NIC) port connector using a

DRL366-3 cable. These connectors have integrated LEDs that display status

of each port. See Table 2 for LED display. The COMMON A PORT link

LED illuminates indicating link has been established between both devices.

Connect COMMON B through COMMON D connectors to other network

tools as desired. using DRL366-3 cables and noting link LED illuminates indi-

cating link has been established between both devices.

Step 4. Connect either;

a) the MANAGEMENT PORT of the 4X16SP-1000BT RJ45 connector to

the network for remote console control,

b) the CONTROL port of the 4X16SP-1000BT USB-style connector to a local

host control console. using the DRL470-6-6-6-6 cable.

Step 5. After the hardware installation is complete, the REMOTEagent and

MANAgents

™

Please refer to the DATACOMswitch

4X16SP-1000BT Copper Gigabit SPAN Switch • USERguide

LED Display

NOTCH UP

NOTCH DOWN

switch control software must be configured or reconfigured.

Datacom Systems Inc

WITH LINK OR DATA

Right LED — Notch Up