- ページ 4

ラベルメーカー Datamax I-Class Mark IIのPDF 設置および使用マニュアルをオンラインで閲覧またはダウンロードできます。Datamax I-Class Mark II 12 ページ。 General purpose input output (gpio) option
Datamax I-Class Mark II にも：クイック・スタート・マニュアル (4 ページ)

ページを印刷する

1. Installing the Option
2. Setup and Operation

Installing the Option

If the GPIO Card is already installed in the printer, skip this section and proceed to

"Configuring the Hardware". Otherwise, install the GPIO Card as described below:

A) Turn off and disconnect the power cord from the printer. Remove the three Screws

from the left side cover of the printer.

B) Open the printer's cover, loosen (do not remove) the two Screws on the inside of the

printer and lift the Cover Assembly up and off the printer.

Screws

Cover

Assembly

Screws