- ページ 6

バーコードリーダー Datamax M-Class Mark IIのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Datamax M-Class Mark II 10 ページ。 Rfid option
Datamax M-Class Mark II にも：マニュアル (6 ページ), マニュアル (8 ページ), クイック・スタート・マニュアル (4 ページ), クイック・スタート・マニュアル (8 ページ), クイック・スタート・マニュアル (6 ページ), クイック・スタート・マニュアル (8 ページ)

 Ensure that the Leveling Cam is

loose, and then close and latch the

Printhead Assembly.

 While pushing down on the

Printhead Assembly, as shown, pull

down on the Side Plate and tighten

the Screw.

Verify Latch Operation:

- Open and close the printhead assembly, verify that the latch is fully engaged. If you are unable to get

the printhead to latch, the side plate is too low.

- Pressing down on the printhead assembly should not cause the latch to loosen or reveal any gap at the

latch point. If there is a gap or movement in the latch then the side plate is too high.

- Print some sample labels. If degraded print quality or ribbon tracking problems are observed then the

side plate is not positioned correctly.

Step 3: Installing the Peel & Present Mechanism

 Position the Peel and Present Mechanism

for mounting on the front of the printer.

 Tighten the Mounting Screw to secure

the mechanism to the printer.

This completes the installation process.

Proceed to Loading Media to begin use.

Mounting Screw

Peel and Present Mechanism

Printhead Assembly

Leveling Cam

Screw

Side Plate