- ページ 9

インターホン・システム 2easy DT43/D4のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。2easy DT43/D4 13 ページ。

ページを印刷する

11.7 User Code Setup

In the DT system,every apartment must have a unique identification called User Code.

The DIP swiches are used to configure the User Code for each Monitor.

•

Bit-1 to Bit-5 are used to User Code setting. The value is from 1 to 32, which have 32

different codes for 32 apartments.

•

When multi Monitors are installed in one apartment, these Monitors have to use the same

User Code setting, and the Master/Slave mode should be set on the Monitor.

•

Bit-6 is line terminal switch, which have to be set to ON if the Monitor is in the end of the

line(bus), otherwise set to OFF. The end of the line is terminal that no other section will

start from it.

Bit state

User Code

Code=1

Code=2

Code=3

Code=4

Code=5

Code=6

Code=7

Code=8

Code=9

Code=10

Code=11

ON(1)

OFF(0)

Bit state

Bit-6 line terminal setting:

Bit state

Setting

Monitor not at

the end of the

line.

User Code

Bit state

Code=12

Code=13

Code=14

Code=15

Code=16

Code=17

Code=18

Code=19

Code=20

Code=21

Code=22

Bit state

Setting

Monitor at

the end of

the line.

User Code

Code=23

Code=24

Code=25

Code=26

Code=27

Code=28

Code=29

Code=30

Code=31

Code=32