2easy DT43/D4 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Домофонна система 2easy DT43/D4. 2easy DT43/D4 13 сторінок.

11.7 User Code Setup
In the DT system,every apartment must have a unique identification called User Code.
The DIP swiches are used to configure the User Code for each Monitor.
Bit-1 to Bit-5 are used to User Code setting. The value is from 1 to 32, which have 32
different codes for 32 apartments.
When multi Monitors are installed in one apartment, these Monitors have to use the same
User Code setting, and the Master/Slave mode should be set on the Monitor.
Bit-6 is line terminal switch, which have to be set to ON if the Monitor is in the end of the
line(bus), otherwise set to OFF. The end of the line is terminal that no other section will
start from it.
Bit state
User Code
Code=1
Code=2
Code=3
Code=4
Code=5
Code=6
Code=7
Code=8
Code=9
Code=10
Code=11
ON(1)
OFF(0)
Bit state
Bit-6 line terminal setting:
Bit state
Setting
Monitor not at
the end of the
line.
User Code
Bit state
Code=12
Code=13
Code=14
Code=15
Code=16
Code=17
Code=18
Code=19
Code=20
Code=21
Code=22
8
Bit state
Setting
Monitor at
the end of
the line.
User Code
Code=23
Code=24
Code=25
Code=26
Code=27
Code=28
Code=29
Code=30
Code=31
Code=32