- ページ 10

自動車アクセサリー DV8 OFFROAD SPEC SeriesのPDF 製品インストールマニュアルをオンラインで閲覧またはダウンロードできます。DV8 OFFROAD SPEC Series 10 ページ。 Rear bumper for 2018+ jeep jl wrangler
DV8 OFFROAD SPEC Series にも：インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (10 ページ), インストレーション・マニュアル (9 ページ)

INSTALLATION

MANUAL

STEP 15 |

To use the nutsert tool,

slider the M6 washer and spacer onto the

provided M6x50 bolt.

Then install a nutsert onto the exposed

threads by hand.

STEP 16 |

Slide the nutsert tool

with the nutsert into the mounting hole.

Ensure the flange of the nutsert is flat

against the vehicle prior to tightening.

STEP 17 |

Use a 12mm wrench to

hold the spacer while tightening with

a 10mm socket. Tighten slowly until

the nutsert is set properly. Do not over

tighten.

Nutsert should be "crushed" against the

inside of the fender so that it is tight and

secure.

When finished remove the nutsert tool

using a 10mm socket and repeat as

needed.

Note: Be sure to hold the spacer tight so it does

not move and scratch paint.

NEED HELP?

855-680-9595