DV8 OFFROAD SPEC Series Manual de instalação do produto - Página 10

Procurar online ou descarregar pdf Manual de instalação do produto para Acessórios para automóveis DV8 OFFROAD SPEC Series. DV8 OFFROAD SPEC Series 10 páginas. Rear bumper for 2018+ jeep jl wrangler
Também para DV8 OFFROAD SPEC Series: Manual de instalação (12 páginas), Manual de instalação (10 páginas), Manual de instalação (9 páginas)

Imprimir página
DV8 OFFROAD SPEC Series Manual de instalação do produto
INSTALLATION
MANUAL
STEP 15 |
To use the nutsert tool,
slider the M6 washer and spacer onto the
provided M6x50 bolt.
Then install a nutsert onto the exposed
threads by hand.
STEP 16 |
Slide the nutsert tool
with the nutsert into the mounting hole.
Ensure the flange of the nutsert is flat
against the vehicle prior to tightening.
STEP 17 |
Use a 12mm wrench to
hold the spacer while tightening with
a 10mm socket. Tighten slowly until
the nutsert is set properly. Do not over
tighten.
Nutsert should be "crushed" against the
inside of the fender so that it is tight and
secure.
When finished remove the nutsert tool
using a 10mm socket and repeat as
needed.
Note: Be sure to hold the spacer tight so it does
not move and scratch paint.
NEED HELP?
855-680-9595