- ページ 6
スプレッダー Agri-Fab 45-02104のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Agri-Fab 45-02104 13 ページ。 Agri-fab 125 lb. push broadcast spreader owner's manual
ページを印刷する16. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut as shown in figure 8.
Tighten carefully. The flow control arm should be
snug, but should pivot with no more than a slight
resistance.
17. Assemble the vinyl grip. See figure 8.
VINYL GRIP
FLOW
CONTROL
ARM
1/4" x 1"
HEX BOLT
(2) NYLON
WASHERS
FIGURE 8
18. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the flow control rod through the
slot in the flow control mounting bracket and through
the hole in the flow control link. Secure with a 3/32" x
3/4" cotter pin. See figure 9.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGURE 9
FLOW CONTROL
MOUNTING
BRACKET
1/4"
NYLOCK
NUT
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
19. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.
HOPPER
FIGURE 10
20. Assemble both the flow control mounting bracket and
the short handle tube to the long handle tube. Use two
1/4" x 1-3/4" hex bolts, four 5/16" flat washers and two
1/4" nylock nuts as shown in figure 11. Do not tighten
at this time.
21. Place a handle grip on each handle. See figure 11.
HANDLE GRIP
1/4" x 1-3/4"
HEX BOLT
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
FIGURE 11
6
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
1/4"
NYLOCK
5/16"
NUT
FLAT
WASHERS