- ページ 7

スプレッダー Agri-Fab 45-02104のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Agri-Fab 45-02104 13 ページ。 Agri-fab 125 lb. push broadcast spreader owner's manual

22. Place the adjustable stop into the "ON" end of the slot

in the top of the flow control mounting bracket. Secure

with the 1/4" x 3/4" carriage bolt, a nylon washer, a

5/16" flat washer and the nylon wing nut. See figure

12.

NYLON

WING NUT

5/16" FLAT

WASHER

NYLON

WASHER

FIGURE 12

ADJUSTABLE

STOP

1/4" x 3/4"

CARRIAGE BOLT

23. Position the flow control mounting bracket (figure

13).

a. Push on flow control arm until it locks in "OFF"

position.

b. Slide flow control mounting bracket along tube until

closure plate in bottom of hopper just closes.

c. Snug the 1/4" lock nuts just enough to hold flow

control mounting bracket in place.

d. Set adjustable stop at "5". Pull flow control arm

against stop. Verify that closure plate has opened

about half way.

e. If closure plate does not open half way, it may be

closed too far at "OFF". Adjust position of flow control

mounting bracket until closure plate will open about

half way at "5" and still close when arm is locked

in "OFF". Tighten 1/4" lock nuts.

FIGURE 13

24. Before operating the spreader, pre-lubricate per the

lubrication instructions in the owner's manual.

AJDUSTABLE

STOP

SETTING "5"