- ページ 2
歩数計 Aussie Fit NANO-ST 3DのPDF ユーザー・インストラクションをオンラインで閲覧またはダウンロードできます。Aussie Fit NANO-ST 3D 2 ページ。 3d motion sensor pedometer with auto exercise timer
HOW TO REMOVE CLIP AND BATTERY SAVING
INSULATOR
1.
Push the clip and the tiny fastener at the same
time to slide off the clip.
2.
Loosen the screw by using a screwdriver.
3.
Pull the insulator out in right direction – see
diagram.
4.
You may place a lanyard if needed by
unscrewing the screw to open the battery door
as shown in diagram below.
5.
Replace the battery door and tighten the
screw.
6.
Replace the clip if required to clip onto a belt
or waistband.
In certain circumstances Aussie Fit Sport Science provides a warranty to repair or replace certain of its goods,
where they are defective, other than resulting from abnormal use, misuse or where the goods have been subject
to any other external factors outside of Aussie Fit Sport Science's control. The benefits under any of Aussie fit
Sport Science's warranties are in addition to other rights and remedies you may have at law.
If you are a consumer as defined in the Australian Consumer law, our goods come with a guarantee that cannot
be excluded under the Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
If your good is defective and it is within the specified warranty period, as indicated on the goods packaging, and
with a receipt of purchase you should contact Aussie Fit Sport Science. Once you have contacted us in some
instances reasonable expenses incurred by you in making the claim may be reimbursed, eg postage but you
must first contact us for authorization. Goods presented for repair may be replaced by refurbished goods of the
same type rather than being repaired. Refurbished parts may be used to repair the goods.
BATTERY SAVING
To save battery power, when no movement is
sensed for 10 minutes, the display will turn off
automatically. Data will not be lost in this sleep
mode. Pedometer movement will automatically turn
the display on.
BATTERY REPLACEMENT
When the display dims, it indicates that the battery
requires replacing. Remove the clip, loosen and
remove the screw on the battery door, replace with
one CR2032 lithium battery.
Attention! Please dispose the used battery in an
ecologically safe manner.
HOW TO WEAR THE PEDOMETER
Pedometer will accurately register steps if placed in a
pocket or carried in a waist bag/bum bag, not
requiring clip. However, with the clip attached it can
be worn in any position on the waist band or belt. It
can also be clipped on to a watchband or wrist band,
for easy viewing.
Aussie Fit Sport Science - Warranty against Defects
Aussie Fit Sport Science
PO Box 3727
Burleigh Town Centre
Burleigh Heads QLD 4220
Ph/Fax: 07 55763688
www.aussiefitsport.com.au