Aussie Fit NANO-ST 3D Instruções de utilização - Página 2

Procurar online ou descarregar pdf Instruções de utilização para Pedómetro Aussie Fit NANO-ST 3D. Aussie Fit NANO-ST 3D 2 páginas. 3d motion sensor pedometer with auto exercise timer

Imprimir página

HOW TO REMOVE CLIP AND BATTERY SAVING

INSULATOR

Push the clip and the tiny fastener at the same

time to slide off the clip.

Loosen the screw by using a screwdriver.

Pull the insulator out in right direction – see

diagram.

You may place a lanyard if needed by

unscrewing the screw to open the battery door

as shown in diagram below.

Replace the battery door and tighten the

screw.

Replace the clip if required to clip onto a belt

or waistband.

In certain circumstances Aussie Fit Sport Science provides a warranty to repair or replace certain of its goods,

where they are defective, other than resulting from abnormal use, misuse or where the goods have been subject

to any other external factors outside of Aussie Fit Sport Science's control. The benefits under any of Aussie fit

Sport Science's warranties are in addition to other rights and remedies you may have at law.

If you are a consumer as defined in the Australian Consumer law, our goods come with a guarantee that cannot

be excluded under the Law. You are entitled to a replacement or refund for a major failure and for compensation

for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or

replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

If your good is defective and it is within the specified warranty period, as indicated on the goods packaging, and

with a receipt of purchase you should contact Aussie Fit Sport Science. Once you have contacted us in some

instances reasonable expenses incurred by you in making the claim may be reimbursed, eg postage but you

must first contact us for authorization. Goods presented for repair may be replaced by refurbished goods of the

same type rather than being repaired. Refurbished parts may be used to repair the goods.

BATTERY SAVING

To save battery power, when no movement is

sensed for 10 minutes, the display will turn off

automatically. Data will not be lost in this sleep

mode. Pedometer movement will automatically turn

the display on.

BATTERY REPLACEMENT

When the display dims, it indicates that the battery

requires replacing. Remove the clip, loosen and

remove the screw on the battery door, replace with

one CR2032 lithium battery.

Attention! Please dispose the used battery in an

ecologically safe manner.

HOW TO WEAR THE PEDOMETER

Pedometer will accurately register steps if placed in a

pocket or carried in a waist bag/bum bag, not

requiring clip. However, with the clip attached it can

be worn in any position on the waist band or belt. It

can also be clipped on to a watchband or wrist band,

for easy viewing.

Aussie Fit Sport Science - Warranty against Defects

Aussie Fit Sport Science

PO Box 3727

Burleigh Town Centre

Burleigh Heads QLD 4220

Ph/Fax: 07 55763688

[email protected]