- ページ 6

高圧洗浄機 Aussie Pumps AB Scud 40のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aussie Pumps AB Scud 40 16 ページ。 Stainless steel frames, 3,000/4,000 psi
Aussie Pumps AB Scud 40 にも：取扱説明書 (16 ページ)

ページを印刷する

Aussie Pumps

ASSEMBLY AND PREPARATION FOR USE

Before proceeding with assembly of your new Aussie

AB Scud Cadet high pressure blaster, check that all

parts listed below are included.

1 x Gun handle assembly



1 x High pressure hose



1 x Lance and nozzle assembly



1 x Foamer (AB30 Hose reel version only)



Machine Preparation (initial start-up)

Breather plug

Pump oil level

1. Check the oil in the pump.

With the machine on a level surface the oil lever

should cover the red spot in the oil level sight

glass on the side of the machine. If necessary, top

up with SAE 75W-90. Do not mix different grades

of oil as this may affect the machines

performance. If alternative oil is used, first empty

out oil by unscrewing drain plug in bottom of

machine.

2. Ensure breather plug is fitted to pump.

WARNING: Before operation ensure top mounted

travel plug is replaced by the yellow breather

plug. Failure to fit breather and keep clean can

result in over pressuring of oil chamber (crank

case) and can blow oil seals. This will void

warranty.

Aussie AB Direct Drive Super Scud Series ... Operation & Maintenance Manual

3. Check oil level in engine and fill with proper

grade oil if necessary. (SAE 10W-30 for Honda

engines, check engine manual for other makes)

4. Check fuel level and fill if necessary. (unleaded

petrol)

5. Assemble gun/lance.

Hose Connections

1. Connect high pressure hose to machine outlet (if

hose reel not fitted).

2. If optional low pressure downstream, in-line

chemical injector is to be used, connect the

injector tube to the detergent inlet and place the

other end of the tube, with the strainer attached,

in the chemical container (not supplied).

3. Connect gun/lance assembly to high pressure

hose.

4. Check inlet water filter is clean then connect

water supply hose to machine. Use a 25mm

(minimum) hose .

Incoming water supply must deliver double the

flow of the machine. If questionable, check supply

at machine. If supply is insufficient, do not operate

from this outlet. For residential use, the outlet

closest to the meter will usually deliver the highest

flow rate. Connect only to clean town water

supply.

Warning:

Do not operate from tank or pond.

Doing so will cavitate the pump

causing damage. Cavitation or pump starvation is

not covered by warranty. Cavitation is a

phenomenon causing vacuum pockets to form

within the pump that eventually implode under

pressure pitting the internal pump surfaces.

Feb 2019