Aussie Pumps AB Scud 40 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Myjka ciśnieniowa Aussie Pumps AB Scud 40. Aussie Pumps AB Scud 40 16 stron. Stainless steel frames, 3,000/4,000 psi
Również dla Aussie Pumps AB Scud 40: Instrukcja obsługi (16 strony)
Aussie Pumps
ASSEMBLY AND PREPARATION FOR USE
Before proceeding with assembly of your new Aussie
AB Scud Cadet high pressure blaster, check that all
parts listed below are included.
1 x Gun handle assembly
1 x High pressure hose
1 x Lance and nozzle assembly
1 x Foamer (AB30 Hose reel version only)
A.
Machine Preparation (initial start-up)
Breather plug
Pump oil level
1. Check the oil in the pump.
With the machine on a level surface the oil lever
should cover the red spot in the oil level sight
glass on the side of the machine. If necessary, top
up with SAE 75W-90. Do not mix different grades
of oil as this may affect the machines
performance. If alternative oil is used, first empty
out oil by unscrewing drain plug in bottom of
machine.
2. Ensure breather plug is fitted to pump.
WARNING: Before operation ensure top mounted
travel plug is replaced by the yellow breather
plug. Failure to fit breather and keep clean can
result in over pressuring of oil chamber (crank
case) and can blow oil seals. This will void
warranty.
6
Aussie AB Direct Drive Super Scud Series ... Operation & Maintenance Manual
3. Check oil level in engine and fill with proper
grade oil if necessary. (SAE 10W-30 for Honda
engines, check engine manual for other makes)
4. Check fuel level and fill if necessary. (unleaded
petrol)
5. Assemble gun/lance.
B.
Hose Connections
1. Connect high pressure hose to machine outlet (if
hose reel not fitted).
2. If optional low pressure downstream, in-line
chemical injector is to be used, connect the
injector tube to the detergent inlet and place the
other end of the tube, with the strainer attached,
in the chemical container (not supplied).
3. Connect gun/lance assembly to high pressure
hose.
4. Check inlet water filter is clean then connect
water supply hose to machine. Use a 25mm
(minimum) hose .
Incoming water supply must deliver double the
flow of the machine. If questionable, check supply
at machine. If supply is insufficient, do not operate
from this outlet. For residential use, the outlet
closest to the meter will usually deliver the highest
flow rate. Connect only to clean town water
supply.
Warning:
Do not operate from tank or pond.
Doing so will cavitate the pump
causing damage. Cavitation or pump starvation is
not covered by warranty. Cavitation is a
phenomenon causing vacuum pockets to form
within the pump that eventually implode under
pressure pitting the internal pump surfaces.
Feb 2019