- ページ 10

コントローラー Datavideo MCU-100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Datavideo MCU-100 18 ページ。 Multi-camera controllers for panasonic cameras
Datavideo MCU-100 にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

1. Connections and Controls

SEL - Select dial

The select dial is used for two functions, to navigate the menus or to

control the shutter speed.

When the MENU button is active and back lit orange. The select dial is

turned to navigate through the camera's menu options. Pressing in the

same dial, like a button, confirms the current selection or value shown.

When the MENU button is NOT active and back lit green. The select

dial can be turned to adjust the SHUTTER speed of the camera.

AWB / ABB switch with LED

This switch is used to trigger Auto White Balance (AWB) or Auto Black

Balance (ABB) adjustment.

AWB: White balance is adjusted automatically. When the W.BAL switch

is set to A or B at this time, the value to which the balance was adjusted

will be stored in memory A or memory B.

ABB: Black balance is adjusted automatically. This value will be stored

in a dedicated ABB memory.

LED ON: Auto white balance / auto black balance in progress.

LED OFF: Auto white balance / auto black balance completed.

LED stops blinking and goes off: Auto white balance / auto black balance

error.

W.BAL switch

This switch is used to recall the preset or stored values of white balance

in the camera.

A or B: This will apply the value stored in the white balance A or B

memory in the camera recorder. When the AWB / ABB switch is set to

the AWB position, the white balance is automatically adjusted and the

value adjusted is stored in the selected memory A or B.

PRST: This will apply the preset value of the white balance stored in the

camera recorder.

CAM A.KNEE switch

To select the video signals to be output from the camera.

BARS: Camera generated colour bar signals are output.

CAM. AUTO KNEE OFF: The images shot by camera are output. The

AUTO KNEE circuit does not work. MANUAL KNEE is set as the

camera recorder's initial setting.

CAM. AUTO KNEE ON: The images shot by the camera are output.

The AUTO KNEE circuit works.

NOTE: AUTO KNEE circuit will not be effective if DRS (Dynamic Range

Stretch) function is enabled. It is also possible allocate the MANUAL

KNEE and DRS functions via the menu settings on the camera.

GAIN switch

Allows selection of the video amplifier's gain depending on the lighting

conditions that are present in the camera's location.

Moving the switch upwards increases the gain in dB steps.

Moving the switch downwards decreases the gain in dB steps.