- ページ 5

ドア開閉システム Cookson FDO-A10EのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Cookson FDO-A10E 19 ページ。 Industrial duty fire door operator

IMPORTANT SAFETY INSTRUCTIONS (CONT.)

4) Test the door's safety features at least once a month. After adjusting either the force or the

limit of travel, retest the door operator's safety features. Failure to adjust the operator

properly may cause severe injury or death.

5) KEEP DOORS PROPERLY OPERATING AND BALANCED. See Door Manufacturer's Owner's

Manual. An improperly operating or balanced door could cause severe injury or death. Have

trained door systems technician make repairs to cables, spring assemblies and other hardware.

6) SAVE THESE INSTRUCTIONS.

1) DISCONNECT POWER AT THE FUSE/BREAKER BOX/DISCONNECT BEFORE PROCEEDING

WITH ANY WIRING OF THIS UNIT.

2) THE UNIT MUST BE PROPERLY GROUNDED. A GROUND SCREW IS SUPPLIED IN THE

ELECTRICAL BOX FOR CONNECTION OF THE POWER SUPPLY GROUND WIRE. FAILURE

TO PROPERLY GROUND THIS UNIT COULD RESULT IN ELECTRICAL SHOCK AND

SERIOUS INJURY.

3) FIELD WIRING OF OPERATOR MUST BE PERFORMED BY QUALIFIED PERSONNEL.

4) OPERATOR MUST BE WIRED PER WIRING DIAGRAMS PROVIDED IN THIS OWNERS

MANUAL ONLY.

5) OPERATOR MUST BE WIRED IN ACCORDANCE WITH LOCAL ELECTRICAL CODES.

NOTE: THE OPERATOR SHOULD BE ON A SEPARATE FUSED LINE OF ADEQUATE

CAPACITY.

6) USE 18 GA STRANDED COPPER WIRE MINIMUM FOR ALL CONTROL CIRCUIT

CONNECTIONS.

7) DO NOT INSTALL ANY WIRING OR ATTEMPT TO RUN THE OPERATOR WITHOUT

CONSULTING THE WIRING DIAGRAM.

8) SET OPERATOR LIMIT SWITCHES BEFORE CONNECTING ANY ENTRAPEMENT

PROTECTION DEVICES TO THE OPERATOR.

Before your operator is installed, be sure the door has been properly aligned and is working

smoothly. Refer to the Door Installation Instructions for proper operator installation. This

motor operator is an integral part of the door system. The motor operator and governor (if

provided) controls door descent speed under power outage conditions.

9001(7) ECN 1057 4/10/010

ELECTRICAL

OPERATOR MOUNTING