- ページ 2

マイク AUSTRALIAN MONITOR AMHEAVYGのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AUSTRALIAN MONITOR AMHEAVYG 2 ページ。 Heavy-duty gooseneck microphone
AUSTRALIAN MONITOR AMHEAVYG にも：取扱説明書 (4 ページ)

ページを印刷する

INSTALLING YOUR AMHEAVYG MICROPHONE

Installing your microphone

1 Choose a suitable flat surface to install the microphone.

2 Using a drill or spade bit drill a 5mm hole in the surface to run the cable through.

3 Using a maker or punch, mark the position of the three holes in the microphone base.

4 Using suitable fasteners secure the microphone in place.

Wiring your microphone

The AMHEAVYG is shipped with an unterminated 5 wire cable. This allows the installer to customise

the connection type between the AMHEAVYG and device input.

The AM HEAVY provides a balanced microphone output signal. It also provides a normally open

(N/O) dry contact closure output from the momentary switch allowing connection to third party

devices such as a pre-announce tone generator.

Please follow the table below for successful wiring and operation of your microphone.

Audio Wiring Termination

Red wire

Audio Positive (+)

Black wire

Audio Negative (-)

Drain / Shield Audio Ground

Base Plate

Dimensions

Switch Wiring Termination

Green wire

Switch

White wire

Switch

(Normally Open N/O)

Typical Polar

Patterns

Typical Frequency

Response

15mm

70mm

Specifications